This truly was touch and go. I’d had the boat hauled in early September to attend to a fairly discrete list of chores: 1) put on fresh bottom paint; 2) have some nice handrails sent by my friends at Boréal welded on to the stern arch; 3) make sure the engine’s running gear was OK after that run-in with a pot warp. It was the last item, of course, that created problems.
Turned out that wrapped pot warp (remember?) had ruined the cutless bearing, and to change that out the prop shaft had to be pulled, and as long as the shaft was out: why not send it on to get it checked to make sure it’s still perfectly straight??? It made sense at the time, but it unfortunately took much longer than it should have. Then there was some head-scratching over Lunacy’s exotic Vetus transmission coupling after the shaft came back, and a missing shaft key, and before I knew it the guys at Maine Yacht Center were relaunching Lunacy (see above) the very morning I planned to take her away south to Annapolis to be in the show again.